Announcement
Collapse
No announcement yet.
Search Result
Collapse
192 results in 0.0343 seconds.
Keywords
Members
Tags
-
You can also choose from the popular tags.
-
I have fitted a petrol cable to a diesel, in my case the only difference was where the rubber mounts where glued on....
- 1 like
-
I don't know a thing about a R series but if you have a vacuum gauge I would use it.
https://www.onallcylinders.com/wp-co...1-752x1024.png
- 1 like
Leave a comment:
-
I think what has happened is someone has fitted the thinner solid disks and thus created a big gap for the pad to fall out of when it gets thin.
- 1 like
Leave a comment:
-
what??? have you got solid disks on a car meant for vented?...
Leave a comment:
-
You can get the pistons and seals if you can get the old one apart.
I think they moved the calipers from trailing edge to leading at some point, so be careful as they swapped side to....
Leave a comment:
-
-
what size is the wiper blade? this is the only new pin type blade I can find, you could ask what size it is.
https://www.ebay.co.uk/itm/335097204...4267&targetid=...
Leave a comment:
-
is this a running engine? you have used the b mark on the pump pulley?
Leave a comment:
-
do not hot wire it, the switch is only held on by two screws and can be turned with a screwdriver. I had to reuse the switch as the plug was different so do not damage it.
not sure about this, look used to me!
https://www.ebay.co.uk/itm/335118906...b581:g:Pe4AAOS...
- 1 like
Leave a comment:
-
I have used speedycables to repair throttle cables before, you could try them.
https://www.speedycables.com/
Leave a comment:
-
-
Skimming will not of helped, but because of the angle of the valve seat the valve will recede a lot for little wear, I think you have enough margin to have the valves resurfaced...
Leave a comment:
-
No you have the same problem, can you post a photo of the side of the valves?
Leave a comment:
-
Hello, Inlet 0.90 to 1.24mm Exhaust 1.30 to 1.64mm.
The after market valves I have used had so much margin that I had to have them refaced so them would meet this, are your valves new or old?
Leave a comment:
-
It go's back to the tank, the Montego's have a restricted pushed into the hose, I think this is to make bleeding easier....
Leave a comment:
Leave a comment: