Maestro Van 500 City 1989 (Old BT) - Rear Wheel Bearings Needed.

[Fug]

Hi

I am looking for rear wheel bearings for my van, I belive there should be an iner and an outer bearing?

In the Past I have got parts that have been advised on the internet for the van but they dont fit, cos the van has parts specific to it.

I don't want to do this again with the bearings,

I would be grateful for any advice.

Thanks Fergus

[Doctordiesel77]

These are the Rover / Unipart numbers for saloon and van, you'll just need to beware of incorrect cross references. Some list the sizes, iirc the car ones are 17 and 27mm id (quite a bit smaller than van) maestrorear.pdf ...only other possible wrong one is if someone tries to palm you off with a two piece front bearing set, which has bigger than van id

[Doctordiesel77]

this one should be right and specifies van often enough to ensure that ebay would refund you if it was wrong. https://www.ebay.co.uk/itm/AUSTIN-MA...QAAOSwJ9RdTH3S

[Fug]

Great Thanks for the info, will go see the fella selling the bearings, his shop is not far from me.