Hello everyone,
My son and I are rebuilding the AN Racing Maestro T16 turbo. My brother and I bought it 11 or so years ago and after a gearbox rebuild and a new LSD we used it on the road for a couple of years then he died and ever since it has sat in dry storage under a tarp. Now my son is of an age that he can help in the rebuild and drive it so it's being resurrected. So far it has had an engine top end rebuild, a modern engine management system with coils on plugs and huge injectors, a new GT2876 turbo, new water injection system, radiator, electronic dash and a full rewire. We have just done a rear disk conversion and while down there we noticed the old LEDA coilovers were well past their best so I ordered some Gaz replacements. Of course the first question they asked was which top mounts we have. Since I have no idea what are fitted on the car, originals I assume, and they are also looking a bit manky so I think we will change them too but no idea where to find the rear ones. Can anyone help?
Does anyone know if they are the same part number at both ends? I anyone aware of any aftermarket fronts with real bearings in them rather than the squashed rubber ring the BL used?
My son and I are rebuilding the AN Racing Maestro T16 turbo. My brother and I bought it 11 or so years ago and after a gearbox rebuild and a new LSD we used it on the road for a couple of years then he died and ever since it has sat in dry storage under a tarp. Now my son is of an age that he can help in the rebuild and drive it so it's being resurrected. So far it has had an engine top end rebuild, a modern engine management system with coils on plugs and huge injectors, a new GT2876 turbo, new water injection system, radiator, electronic dash and a full rewire. We have just done a rear disk conversion and while down there we noticed the old LEDA coilovers were well past their best so I ordered some Gaz replacements. Of course the first question they asked was which top mounts we have. Since I have no idea what are fitted on the car, originals I assume, and they are also looking a bit manky so I think we will change them too but no idea where to find the rear ones. Can anyone help?
Does anyone know if they are the same part number at both ends? I anyone aware of any aftermarket fronts with real bearings in them rather than the squashed rubber ring the BL used?
Comment